Porsche 968

PINION BEARING FAILURE IN POWER TRAIN OF PORSCHE 968 MODEL CARS - MANUFACTURING DEFECT, WITHOUT RELATIONSHIP TO DRIVING CONDITIONS OR WEAR AND TEAR. MAJOR SAFETY CONCERN. EXTREMELY HIGH COST TO REPAIR - SHOULD BE SUBJECT TO IMMEDIATE RECALL. *JB

THERE EXISTS A KNOWN ISSUE WITH THE PINION BEARING IN THE TRANSAXLE. THIS ISSUE HAS BEEN DOCUMENTED BY DEALERS, CONSUMERS, AND THE MANUFACTURER. TO DATE, THERE HAVE BEEN HUNDREDS OF KNOWN FAILURES - CONSIDERING THAT PORSCHE PRODUCED LESS THAN 12,780 OF THESE VEHICLES WORLDWIDE OVER FOUR YEARS, THE RATIO OF FAILURES IS ALARMINGLY HIGH. TO DATE, PORSCHE HAS REJECTED CLAIMS FROM CONSUMERS FOR THE REPAIR OF FAILED UNITS AND CONTINUES TO IGNORE THE PROBLEM WHICH UNADDRESSED CAN RESULT IN…

KNOWN PINION BEARING ISSUE HAS BEEN IGNORED BY PORSCHE FOR YEARS. THERE ARE HUNDREDS OF KNOWN CASES OF THIS BEARING FAILURE YET PORSCHE OUTRIGHT DENIES A PROBLEM. WITH LESS THAN 12,780 UNITS PRODUCED WORLDWIDE OVER FOUR YEARS, THE RATIO OF FAILED UNITS OF QUITE HIGH BY ANY STANDARD. THERE EXISTS THE POTENTIAL OF CAUSUALTIES SHOULD THIS FAILURE BE IGNORED AND OCCUR WHILE DRIVING IN TRAFFIC. WHILE THERE TYPICALLY IS WARNING THAT THE BEARING IS FAILING, MANY PEOPLE CONTINUE TO DRIVE THE…

ALL ELECTRICAL POWER STOPS ABRUPTLY IMMEDIATELY KILLING THE ENGINE AND ALL POWER TO LIGHTS. YOU CAN'T EVEN PUT ON EMERGENCY FLASHERS SINCE THERE IS NO ELECTRICAL POWER. APPEARS TO HAPPEN WHEN A HIGHER ELECTRICAL LOAD IS INTRODUCED SUCH AS A/C OR HIGH BEAMS ARE USED. MOST RECENTLY, THIS HAPPENED ON A TWO LANE HIGHWAY WHERE THE ONLY LIGHTS AVAILABLE WERE THE VEHICLE HEADLIGHTS. WHEN ALL POWER STOPPED AT CLOSE TO 60MPH IT WAS PITCH BLACK. WITHOUT KNOWING THE SIDE OF THE ROAD, I HAD NO CHOICE…

VEHICLE EXHIBITED A NUMBER OF WARNING LIGHTS,CONTINUOUS RUNNING OF THE COOLING FAN AND FINALLY QUIT RUNNING. A SMELL OF BURNING WIRES WAS NOTICEABLE IN THE PASSENGER COMPARTMENT. VEHICLE WAS TOWED TO AN AUTHORIZED POR SCHE DEALERSHIP HWERE I WAS ADVISED OF A DEFECTIVE WIRING HARNESS. THE TECHNICIAN STATED THAT IT WAS A KNOWN PROBLEM AS THE HARNESS TENDED TO BECOME BRITTLE AND A NEW TYPE OF HARNESS WOULD BE INSTALLED.PORSCHE AGREED TO COVER THE PART BUT NO LABOR. THE BURNING OF THE HARNESS…

THIS FAILURE HAS OCCURRED ON OVER 100 OTHER PORSCHE 968 OWNERS (LIST ON INTERNET UNDER 968 CLUB). PORSCHE REFUSES TO IDENTIFY THIS WIDE SPREAD MANUFACTURING DEFECT AS A RECALL. THIS INHERENT FAILURE DUE TO MANUFACTURING MIS ALIGNMENTS IN THE PINION BEARINGS THAT OCCURRED DURING MANUFACTURING COULD LEAD TO SERIOUS INJURIES.*AK

PINION BEARING, FAILED RESULTING IN $1,800 REPAIR TO TRANSMISSION; ACCORDING TO PORSCHE DEALERSHIP THIS FAILURE WAS A RESULT OF A MANUFACTURING DEFECT, AND IS PRESENT IN MOST 968'S. *AK

TRANSMISSION FAILED DUE TO TOO MUCH FACTORY PRE-LOAD ON THE PINION BEARINGS AND ASSOCIATED PARTS. MJS

MANUAL TRANSMISSION FAILURE(BEARING AND GEAR SET WEAR) CAUSED BY TOO MUCH FACTORY PRE-LOAD ON BEARING/GEAR SET ASSEMBLY. *AK

PROBLEM WITH CONVERTIBLE TOP. *AK